Care

Leaving your board in the sun and in hot cars for extended periods will cause delamination – This will void your SURFOILZ Warrantee

INSERTED BOARD COMPONENTS:

Your board will have several components added during the manufacturing process – these maybe

FOIL TRACK BLOCK- 

Ensure your Mast vendor supplies TEE NUTS that are compatible with the TRACK BLOCK – if necessary, you may need to have them modified.

AIR VALVE – 

These are pre-set on installation to allow for pressure variations within the core and should not be adjusted or removed

Tampering with the Air Valve - voids the SURFOILZ Warrantee

Please Note- These valves are not capable of dealing with overheating situations when the board is left in the sun.

LEASH PLUG- 

We use large format plugs to ensure easy Leash connection – Ensure they are clean

FOOT STRAP INSERTS- (4 screw) installed into High Density Foam plugs 

It is imperative that you only use the Screws supplied with the Strap Inserts 

Using other SCREWS will void the SURFOILZ Warrantee

SECURING MASTS & FOOTSTRAPS- we have a couple of experiences where Foilers have damaged their boards when connecting Masts and Foot Straps. In all cases it is either due to not using the correct Tee Nuts or Strap Screws, or using a Power Tool which will create unnecessary stress on the connection - DO NOT USE POWER TOOLS - USE ONLY HAND TOOLS

Failure to do so voids the SURFOILZ Warrantee.

If you unfortunately damage your board, get it repaired IMMEDIATELY, ensure that any water absorption is evaporated - do not leave the board in the sun to dry out, do not ride your board until it has been repaired with epoxy resin by someone who can prove their experience with using epoxy resin.